For this project I used 8cm thick oak planks. I started by marking the cuts on each plank not paying much attention to cracks and knots as I planned to fill them up with epoxy later on. After cutting on a band saw, each oak plank was planed to a flat surface on 3 sides and to a right angle in between each side. Planks are then planed down to thickness of 66mm and fingerjointed. For glueup, I used d3 acetate glue with open time of approx. 20 minutes at room temperature so we had to work fast. The glue was left to set over night. After removing clamps, board was left to rest for a few days before trimming and planing on a kuka kr150 cnc robotic arm. on the under side of the table top, I milled a groove where table base will be positioned later on. For filling up the cracks and knots, I used clear epoxy resin with black pigment mixed in. After the resin was set, excess was sanded off and a layer of clear resin was applied to whole surface to fill the pores. Excess was once again sanded off and 3 coats of clear m
1 view
1393
340
5 months ago 00:12:59 1
Браслет.Ндебеле.
5 months ago 06:19:20 1
Yes, Your Grace | Complete Gameplay Walkthrough - Full Game | No Commentary
5 months ago 00:04:31 1
The Treatment “When Thunder and Lightning Strikes“ - Official Music Video
5 months ago 00:58:13 1
Songs for warriors in BERSERK MODE 🔥🥶
5 months ago 00:02:24 1
Sturmgeschutz III Ausfuhrung G Assault Gun Walkaround - Overloon
5 months ago 01:09:49 1
Global Influence: China’s Carrot and the US Stick
5 months ago 00:04:02 1
We Love Cold War!! (Short Anime Film)
5 months ago 00:00:16 1
Palworld - Official Arena Teaser Trailer | Triple-I Initiative Showcase
5 months ago 00:03:57 1
Baby Rose produced by BADBADNOTGOOD - Slow Burn (Official Visualizer)