FPV ORCA V2 3D Printed RC | Full Build

STL Files: STL Files coupon 10% OFF: troyorcav2stl Printed Kits 5% OFF: troyorcav2printed Thank you so much for watching! If you like videos like this, consider buying me a coffee, it really supports me: See what else I am working on: @troymcmillan_rc #3DPrinted,#RCAirplane, #ItFlies Parts Required For this Build: 2207.5 2450 KV Brushless Motor: 30amp ESC: APC 6x4EP Prop: 1000mAh Battery: Screw assortment: 5mm Carbon Rod: 4x ES08Mll Servos: Or 4x Cheap servos: Supplies used: FLSUN Super Racer: AnyCubic Kobra: AnyCubic Vyper: ABS for motor mount: 3DLabPrint PolyLight 1.0: ColorFabb LW-PLA: eSun PLA : TPU: Spektrum DX6 Controller: Spektrum NX10 Controller: Receiver: Battery Charger: Charge cable: Xt60 connector: Assortment of 3-Pin Extension Cables: Z-Bend pliers: 2mm push rod ends: CA Glue: CA Accelerator: Low-Voltage Tester: Hot knife: Drill Bits: Hobby Knife: #11 blades: Build Mat: Onboard Camera: Lead weight: Soldering Iron: Printer Settings: For printing the Orca V2 I used the FLSUN Super Racer that has a Bowden tube. These are the settings I used to slice my own STL files in Cura. The only settings you should need to adjust from these are individual printer settings like retraction and priming. There is also a slicing table at the bottom of the PDF, that outlines the few parts that need different top and bottom layers and infill settings. It also has the weights listed on the PDF to check your weights against. Quality: Layer Height – 0.2 Initial Layer Height - Line Width – Walls: Wall Line Count – 1 Z Seam Alignment - User Specified Z Seam Position - Back (Position part to align Z seam) Seam Corner Preference - Hide Seam or Expose Seam Top/Bottom: Top Layers - 0 Bottom Layers - 2 Initial Bottom Layers - 2 Infill: Infill Density – 0% Material: PLA Printing Temperature – 215 Build Plate Temperature – 60 Flow – 102% Speed: Print Speed – 100 mm/s Outer Wall Speed – 50 mm/s Inner Wall Speed – 50 mm/s Travel Speed – 150 mm/s Travel: Enable Retraction – Checked Retraction Distance – (Bowden Tube FLSUN Super Racer) Retraction Speed – 40 mm/s Retraction Extra Prime Amount – 0.2 Combing Mode – off Cooling: Enable Print Cooling – Checked Fan Speed – 80% Support: Generate Support - NOT Checked Build Plate Adhesion: Build Plate Adhesion Type - Skirt Skirt Line Count - 2 Mesh Fixes: Union Overlapping Volumes – Checked Special Modes: Surface Mode – Normal Experimental: Slicing Tolerance – Middle Disclaimer: I am sponsored by some of the products I mention. However, all of my opinions are my own. Some of the above links are affiliate links, that does not effect the price you pay for a product, but I may receive a small commission if you make a purchase. This helps support my channel and allows me to continue to make videos like this. Thank you for your support!!