Display stand for Star Destroyer - Star Wars

STL- I designed the Star destroyer display stand you’ve all been waiting for. The main features of this display stand are: 1. It was sculpted to match well with the design of the Star Destroyer. 2. And it was designed high so that the lower part of the Star Destroyer can be clearly seen. 3. Therefore, it was important to balance the display stand according to the center of gravity, and this was accomplished well. In the movie, the CR90 corvette and Millennium Falcon are deeply involved in the story. So it includes a CR90 corvette and a Millennium Falcon. However, it was designed to be slightly larger than the actual scale. This is because if made at the original scale, it would be too small to print. The location of these spacecraft was created on a display stand, with the CR90 corvette in the front and the Millennium Falcon in the back. The Imperial Army’s logo was designed to rotate and stand upright. I hope this display stand will be a great way to display your Star destroyer design! Largest part in printing, size= X 120mm, Y 130mm, Z 160mm, After full assembly size= X 120mm, Y 130mm, Z 160mm Total Build Time : 10h 35m / Plastic Weight : 39g