What is Klipper?

Klipper is the next evolution of 3D printer operating systems. Klipper is the firmware that resides on the microcontroller in your printer. It takes all the calculations that the printer has to do to move the print head and the bed to their proper positions while maintaining the heat of both the extruder and the bed and controlling how much hot melty plastic squirts out of the tip; and it lets a separate processor handle all of it. All Klipper on the printer does is accept commands from the other processor. This being many times more powerful can process the data at speeds a little STM MCU could never handle. Here is more information about Klipper and it’s parters Fluidd and Moonraker. Klipper: Fluidd: Moonraker: ************************************************************************* *Please help support this channel at NO COST TO YOU. If you shop on* *Amazon, please use this link: * *I will get a small commission and it costs you nothing. * ************************************************************************* HEY YOU ABOUT TO POST SOMETHING STUPID: Yes, I know my hands are large/fat. It’s because of a heart condition I suffer from called Congestive Heart Failure. Here’s a link to some information about CHF: One of the symptoms is that it causes fluid retention, mostly in the hands, feet/ankles, and face.. ------------------------------------------------------------------------------------------------------------------- Support learnelectronics: Amazon Store: If you are shopping for electronic components, test gear or consumables please consider visiting my Amazon shop @ Patreon: Please check out and pledge a dollar if you can. It will go a long way to keeping the channel alive. It costs a bit of money to buy all the items and produce these videos. Your help is appreciated. Paypal: you’d like to send a one-time donation you can use this link: --------------------------------------------------------------------------------------------------------------------- Gear I use: Multimeter: OWON B33 Oscilloscope: KIPRIM DS1202 Signal generator: Junctek JDS8080 Component Tester: T7 Multifunction Soldering Station: Sealody ???????