🎯 Загружено автоматически через бота:
🚫 Оригинал видео:
📺 Данное видео принадлежит каналу «mr-fix» (@mrfixpl). Оно представлено в нашем сообществе исключительно в информационных, научных, образовательных или культурных целях. Наше сообщество не утверждает никаких прав на данное видео. Пожалуйста, поддержите автора, посетив его оригинальный канал.
✉️ Если у вас есть претензии к авторским правам на данное видео, пожалуйста, свяжитесь с нами по почте support@, и мы немедленно удалим его.
📃 Оригинальное описание:
While attempting to upgrade the firmware from 02xx to 04xx I managed to lock my #MIB2 Technisat unit due to bad file provided with the custom update. I was hoping to convert the unit to the facelift software version and I got stuck with red screen and #Emergency Download, the only way to turn off the radio was by removing the QuadLock connector from the main unit.
ℹ️ I’ve created a custom update to restore stock swdownload app instead of the patched one. Red screen was gone, VW logo appeared but the unit was now in boot loop and every 30 seconds it rebooted.
I’ve prepared an SD card with previous firmware, inserted it in SD1 port, connected USB-to-UART converter to the QuadLock, opened the unit and shorted two point with tweezers while powering the device. This way I was able to see #recovery menu on my PC, and by selecting “2“ I choose emergency download mode.
Powered of the device, waited 10 seconds, powered it back on, the unit started in Emergency Download mode, and immediately detected the SD card with firmware files. After 30 minutes or so system was restored to stock. Component protection was not triggered, factory installed FEC/SWaP codes were present and valid.
🔌 PuTTy Serial COM with 115200bps; level; Rx to Tx, Tx to Rx, Gnd to Gnd.
💻 Firmware used to restore: MST2_EU_VW_ZR_P0254T
🚗 MIB2 Technisat/Preh units can be found in VAG cars like Volkswagen, Seat, Skoda.
🚙 MIB2 Delphi and Harman units can be found in VAG cars like Audi, Sear, Skoda, Volkswagen, Porsche, Lamborghini. Procedure might be different for those units.
MIB2 boot loop
Error while 04xx firmware conversion
Red screen emergency download
Disconnect QuadLock to turn off unit
Recovery UART cable
UART connection and live logs
Recovery menu
Blue screen emergency download
Restored system test
UART tips
That’s it!
✅
✅ Facebook:
✅ Instagram:
✅ Patreon:
12 views
0
0
2 months ago 00:06:40 94
[MIB Helper] How to connect with MIB J5 via Serial UART TTL