NEW VSETT 10+ DISPLAY UNPACKING and INSTALLATION 9-26-2022

00:00 Unpacking 02:40 Preparations 04:09 Temporarily removing Zukka accessory bracket 06:-02 Sizing up installation of New display’s bracket 07:00 Using tape to pre-mark handlebar position for re-install later 07:46 Removing original handlebar bracket and installing New handlebar bracket for display 14:35 Re-installing the Zukka accessory bracket 15:57 Test fit of New display in New bracket and Pre-test the display for operation(pass/fail) 21:25 Pre-Procedures for removing right grip with integrated turn-signal switch 22:39 Loosing setscrew on handlebar knob allowing the handlebar to pivot 25:00 Removal of right grip(sorry the camera was not positioned 100% to see) 29:19 Right grip removed and make note NOT to put stress on turn-signal wire 29:45 How to mark position of right brake lever assembly orientation and removal 32:12 Removal of original display/throttle assembly 34:15 Reinstall of right brake lever assembly (a mistake at this point) 36:19 Install of New throttle/speed assembly 37:35 Reinstall of right brake lever assembly 39:11 Reinstall of right grip with integrated turn-signal switch(much detail this time) 43:16 Screws(2) for New display 45:24 Notes on zip tie placement (suggestions) 46:56 Highlighting features of new display