How to write firmware for custom ESP32-based hardware. Example features an ESP32-C3 MCU with QSPI flash memory, SPI inertial measurement unit (sensor), USB, LEDs, and PCB antenna (WiFi). PCBs by PCBWay
Board bring-up using the Arduino IDE for simplicity.
[SUPPORT]
Free trial of Altium Designer:
PCBs manufactured and assembled by PCBWay:
Patreon:
Mixed-signal hardware design course:
Advanced Hardware Design Course Survey
[GIT]
[LINKS]
Instagram:
ESP32 Hardware Design Video:
Additional board manager URLS: ,
[TIMESTAMPS]
00:00 Introduction
02:02 Altium Designer Free Trial
02:27 PCBWay
03:04 Hardware Overview
05:30 Arduino IDE Set-Up for ESP32
06:35 Board Set-Up
09:00 Flashing Firmware
10:27 LED GPIOs
12:57 USB Serial
14:02 SPI Sensor Interface, Basic Set-Up
18:34 SPI Protocol Basics, Read Register Implementation
24:50 SPI Test (Chip ID and Temperature Sensor)
28:06 WiFi Test (Basic Server to Toggle LED)
31:12 Outro
1 view
1062
327
1 week ago 00:01:41 1
Самонаводящаяся камера на основе OpenCV, Nvidia Jetson Nano и ESP32
2 weeks ago 02:57:19 4
How to Make Custom ESP32 Board in 3 Hours | Full Tutorial
3 weeks ago 01:21:01 3
Asking Peter with 100 000+ students: How to Learn Electronics and Programming? | Peter Dalmaris
3 weeks ago 00:10:01 10
Нагрузочный модуль (1А и 2А) для USB тестера KEWEISI. Load module (1A and 2A) for USB tester KEWEISI