SkyRC B6 mini & B6AC V2 charger Calibration

This videos shows how to calibrate your SkyRC B6 mini & B6AC V2 charger successfully. But first you need to upgrade your firmware first: B6 mini firmware: B6AC V2 firmware: --Download the software to upgrade your B6mini charger. --Better to extract it onto desktop --Connect the B6 mini charger to your computer, upgrade the charger as the video shows. --It’s normal when you see the notice “DC IN TOO LOW“ during upgrading, just ignore it, and do not disconnect the connection. --After upgrading, pls Load Factory Reset. --Calibration is only available with a 6S battery, so pls prepare a 6S battery first. --Check the voltage of each cell first. Make sure voltage of each cell is higher than . If it’s per cell, that would be better. --Connect the 6S battery to the charger’s balance port. --Find the BATT METER, press ENTER button to check the voltage. --Then press and hold ENTER button for around 6 seconds, entering into the calibration process. --Start calibrating according to the voltage tested by multi-meter. --After the calibration is done, press and hold the ENTER button for around 6 seconds. If you’ve finished above procedure successfully, congratulations.